在濟南的大街小巷，卷簾門作為守護商鋪、車庫的 “衛士”，選對尺寸才能既實用又美觀。但面對五花八門的規格，不少人犯了難：尺寸選小了門用不了，選大了浪費空間還影響安裝。其實，挑選卷簾門尺寸有章可循，從門洞測量到預留余量，每個細節都藏著 “黃金法則”。

　　In the streets and alleys of Jinan, rolling shutter doors serve as the "security guards" guarding shops and garages. Choosing the right size is both practical and beautiful. But faced with a variety of specifications, many people find it difficult: choosing a smaller size makes the door unusable, choosing a larger size wastes space and affects installation. In fact, there are rules to follow when choosing the size of a rolling shutter door, from measuring the door opening to reserving space, every detail hides the "golden rule".

　　精準測量：打好尺寸選擇的地基

　　Accurate measurement: laying the foundation for size selection

　　測量門洞尺寸是挑選卷簾門的步，誤差需控制在毫米級。測量門洞的寬度，在門洞上、中、下三個位置分別測量，取小值作為寬度基準，因為墻面可能存在不平整的情況。例如，某商鋪門洞上部寬 3020 毫米、中部 3015 毫米、下部 3010 毫米，那么應以 3010 毫米作為寬度尺寸。高度測量同樣分左、中、右三個點，記錄小值。車庫卷簾門還需注意頂部空間，測量從門洞上沿到天花板的距離，這個尺寸決定卷簾門卷軸安裝后是否會與天花板沖突。對于不規則門洞，要測量多個關鍵點位，繪制草圖標注數據，為定制卷簾門提供準確依據。

　　Measuring the size of the door opening is the first step in selecting a rolling shutter door, and the error should be controlled within millimeters. Firstly, measure the width of the door opening at the top, middle, and bottom positions, and take the minimum value as the width reference, as there may be unevenness on the wall surface. For example, if the upper part of a shop's doorway is 3020mm wide, the middle part is 3015mm wide, and the lower part is 3010mm wide, then 3010mm should be used as the width dimension. Height measurement is also divided into three points: left, center, and right, and the minimum value is recorded. Attention should also be paid to the top space of the garage rolling shutter door, measuring the distance from the top edge of the door opening to the ceiling. This size determines whether the rolling shutter door scroll will conflict with the ceiling after installation. For irregular door openings, it is necessary to measure multiple key points, draw sketches and annotate data to provide accurate basis for customizing rolling shutter doors.

　　適配場景：不同用途的尺寸考量

　　Adaptation scenarios: Size considerations for different purposes

　　卷簾門的使用場景直接影響尺寸選擇。濟南的商鋪門面，為保證通行便利和視覺效果，寬度一般比門洞寬 100 - 200 毫米，高度比門洞高 50 - 100 毫米，這樣既便于安裝固定，又能完全遮蓋門洞縫隙。比如人流量大的小吃街商鋪，卷簾門寬度在 3 米 - 4 米較為合適，既能滿足顧客進出需求，又不會因過寬導致開關緩慢。車庫卷簾門尺寸則需適配車輛進出，小型家用車庫門寬度通常在 2.1 - 2.4 米，高度 2 - 2.2 米，確保轎車、SUV 等常見車型順利進出；若是商用貨車車庫，寬度可能要達到 3.5 - 4 米，高度 3 - 3.5 米，以適配大型車輛的通行。

　　The usage scenario of rolling shutter doors directly affects the size selection. In order to ensure convenient transportation and visual effects, the storefront of shops in Jinan is generally 100-200 millimeters wider than the door opening and 50-100 millimeters higher than the door opening. This not only facilitates installation and fixation, but also completely covers the gaps in the door opening. For example, in snack street shops with high foot traffic, a rolling shutter door width of 3-4 meters is more suitable, which can meet the needs of customers entering and exiting without causing slow opening and closing due to excessive width. The size of the garage rolling shutter door needs to be adapted to the entry and exit of vehicles. Small household garage doors usually have a width of 2.1-2.4 meters and a height of 2-2.2 meters, ensuring smooth entry and exit for common car models such as sedans and SUVs; If it is a commercial truck garage, the width may need to reach 3.5-4 meters and the height may need to be 3-3.5 meters to accommodate the passage of large vehicles.

　　預留空間：為安裝和使用留有余地

　　Reserved space: leaving room for installation and use

　　除了門洞尺寸，還需考慮卷簾門的安裝和運行空間。卷簾門在收起時，卷軸和簾片會占用一定的上方空間，因此門洞上方少要預留 200 - 300 毫米的空間用于安裝卷軸。若空間不足，卷簾門可能無法完全收起，甚影響正常使用。兩側也要預留 50 - 100 毫米的空間，用于安裝導軌和固定支架，保證卷簾門升降順暢。此外，若門洞附近有管道、電線等障礙物，要提前規劃好卷簾門的尺寸和安裝位置，避免相互干擾。比如老舊小區車庫上方有下水管道，就需要調整卷簾門高度，確保門體運行不受阻礙。

　　In addition to the size of the door opening, the installation and operating space of the rolling shutter door also need to be considered. When the rolling shutter door is retracted, the scroll and curtain will occupy a certain amount of upper space, so at least 200-300 millimeters of space should be reserved above the door opening for installing the scroll. If there is not enough space, the rolling shutter door may not be able to be fully retracted and may even affect normal use. A space of 50-100mm should also be reserved on both sides for installing guide rails and fixing brackets to ensure smooth lifting of the rolling shutter door. In addition, if there are obstacles such as pipelines and wires near the door opening, the size and installation position of the rolling shutter door should be planned in advance to avoid mutual interference. For example, if there is a sewer pipe above the garage in an old residential area, it is necessary to adjust the height of the rolling shutter door to ensure that the operation of the door is not obstructed.

　　特殊需求：個性化場景的尺寸方案

　　Special Requirements: Size Scheme for Personalized Scenarios

　　對于有特殊需求的場所，卷簾門尺寸需靈活調整。濟南的一些大型倉庫，為了便于大型貨物運輸，會選擇超大尺寸的卷簾門，寬度可達 6 - 8 米，高度 4 - 5 米。這種超大門型需要加強門體結構，選擇更堅固的材質和更大功率的電機，確保門體穩定運行。而別墅庭院的卷簾門，除了滿足通行功能，還要兼顧美觀與協調性，尺寸可以根據庭院整體風格和建筑比例進行定制，例如寬度與院墻同寬，高度與院墻高度適配，打造和諧統一的視覺效果。

　　For places with special requirements, the size of the rolling shutter door needs to be flexibly adjusted. Some large warehouses in Jinan choose oversized rolling shutter doors with a width of 6-8 meters and a height of 4-5 meters to facilitate the transportation of large goods. This oversized door type requires strengthening the door structure, selecting stronger materials and higher power motors to ensure stable operation of the door. The rolling shutter doors in the villa courtyard, in addition to meeting the traffic function, also need to consider aesthetics and coordination. The size can be customized according to the overall style and building proportion of the courtyard, such as the width being the same as the courtyard wall, and the height being adapted to the height of the courtyard wall, creating a harmonious and unified visual effect.

　　挑選濟南卷簾門尺寸，就像為門洞 “量體裁衣”。從精準測量、適配場景，到預留空間、滿足特殊需求，每個環節都關乎卷簾門的實用性與性。只有掌握這些尺寸挑選要點，才能選到合適的卷簾門，讓它成為守護空間的可靠屏障。

　　Choosing the size of a rolling shutter door in Jinan is like tailoring the door opening. From precise measurement and scene adaptation, to reserving space and meeting special needs, every step is related to the practicality and safety of rolling shutter doors. Only by mastering these size selection points can one choose the appropriate rolling shutter door and make it a reliable barrier to protect the space.

　　本文由濟南卷簾門友情奉獻.更多有關的知識請點擊:http://m.santoncc.cn真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Jinan Rolling Shutter Doors For more information, please click: http://m.santoncc.cn Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.