現在很多人的商店或者車棚都會安裝電動卷簾門，但是電動卷簾門使用時間長了，各個部件就會松動，上下移動的時候電動卷簾門跑在軌道上，如果出了問題的卡塞，可能會導致整個電動卷簾門從軸上掉下來，對周圍的人造成傷害。那么當電動卷簾門脫軸時會發生什么？應該如何處理？

At present, many people's shops or car sheds will be equipped with electric roller shutter doors. However, the electric roller shutter doors will become loose when they are used for a long time. When they move up and down, the electric roller shutter doors will run on the track. If there is a jam, the entire electric roller shutter door may fall off the shaft, causing harm to the people around. So what happens when the electric roller shutter door is off-axis? What should be done?

電動卷簾門脫軸有哪些情況？

What are the conditions of the off-axis of the electric roller shutter door?

固定座上有螺栓。如果這個螺栓松動，也會導致電動卷簾門稍后脫落，造成危險。電動卷簾門葉片的連接也會導致脫鉤，或者如果其中一個固定螺絲松動，整個門也會脫落。

There are bolts on the fixing seat. If the bolt is loose, the electric roller shutter door will fall off later, causing danger. The connection of the blades of the electric roller shutter door will also cause decoupling, or if one of the fixing screws is loose, the whole door will also fall off.

電動卷簾門脫軸怎么辦？

What if the electric roller shutter door is off-axis?

1、取下卷線器，將其放在墻壁兩側的固定支架上。之后，取下上面的螺絲，然后將窗簾固定在卷簾上。然后把卷簾掛在卷軸上，上面有一些孔，對著螺絲固定，然后用電機把卷簾卷到一定的位置，調整一下，看能不能正常運行。

1. Remove the winder and place it on the fixing brackets on both sides of the wall. After that, remove the upper screws, and then fix the curtain on the roller shutter. Then hang the roller shutter on the roller with some holes on it, fix it against the screws, and then use the motor to roll the roller shutter to a certain position and adjust it to see if it can operate normally.

2、如果電動卷簾門卷軸壞了，只能更換新的，同時檢查電動卷簾門軸管的螺栓是否松動。購買后，先將軸管安裝到位，同時將螺栓擰緊，確保沒有松動的問題。

2. If the roller of the electric roller shutter door is broken, it can only be replaced with a new one. At the same time, check whether the bolts of the roller tube of the electric roller shutter door are loose. After purchase, install the shaft tube in place and tighten the bolts to ensure there is no looseness.

3、同時還要檢查電動卷簾門的門片是否脫落。如果不正常，要及時檢查故障進行維修。安裝時，請務必遵循正確的方法。安裝后，電動卷簾門的軌道不要涂油，因?yàn)樗苋菀谆瑒?dòng)。

3. At the same time, check whether the door leaf of the electric rolling shutter door falls off. If it is abnormal, the fault shall be checked and repaired in time. When installing, be sure to follow the correct method. After installation, the track of the electric roller shutter door should not be oiled because it is easy to slide.

4、如果電動卷簾門脫軸，可能與線路有關。例如，控制線中的某些線連接不正確，或被拉斷。，檢查電路的問題。有電機引線。如果和繼電器的插頭有關系，因?yàn)檎饎?dòng)和脫落也很容易造成故障，所以需要重新修理電線。

4. If the electric roller shutter door is off-axis, it may be related to the circuit. For example, some of the control lines are incorrectly connected or are pulled apart. First, check the circuit. There are motor leads. If it is related to the plug of the relay, it is easy to cause faults due to vibration and falling off, so the wires need to be repaired again.

電動卷簾門彈簧斷了怎么辦？

What if the spring of the electric roller shutter door breaks?

如果電動卷簾門的彈簧已經壞了，只能更換新的彈簧進行維修。安裝時，需要一只手和另一只手握住彈簧筒，并用扳手將其上的螺絲卸下。先將彈簧蓋安裝在電動卷簾門上，固定好螺絲，再擰緊彈簧，即可安裝到位。濟南卷簾門小編總結：當發現家里的電動卷簾門脫軸或者彈簧壞了，需要及時修復。如果只是脫軸，軸管壞了，換上新的再安裝即可。

If the spring of the electric roller shutter door is broken, it can only be replaced with a new spring for maintenance. During installation, hold the spring cartridge with one hand and the other hand, and use a wrench to remove the screws on it. First install the spring cover on the electric roller shutter door, fix the screws, and then tighten the spring to install it in place. Jinan rolling shutter door editor summary: when the electric rolling shutter door at home is found to be off-axis or the spring is broken, it needs to be repaired in time. If only the shaft is off and the shaft tube is damaged, replace it with a new one and then install it.

以上就是問題解答的相關內容了，希望能夠幫助到大家，如對這一問題還存在任何疑問，都?xì)g迎關注我們網站http://m.santoncc.cn并咨詢我們的工作人員，將竭誠為您服務。

The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://m.santoncc.cn And consult our staff, will serve you wholeheartedly.