自動卷簾門在現代生活中常常會使用到，比如說、商店、車庫、工廠等行業都可以看卷簾門的身影。自動卷簾門安裝后，調試過程也非常重要，那么自動卷簾門的升降+-怎么調呢？濟南卷簾門廠家馬上就為大家介紹下相關方法，希望對大家有所幫助。

Automatic roller shutter doors are often used in modern life. For example, supermarkets, stores, garages, factories and other industries can see the figure of roller shutter doors. After the automatic rolling shutter door is installed, the commissioning process is also very important. How to adjust the lifting+- of the automatic rolling shutter door? Jinan roller shutter door manufacturer will introduce relevant methods to you immediately, hoping to help you.

調升降前，先將限位機構上的螺釘調松，用手拉動鏈條讓卷簾門保持在地面1米左右。按下遙控器的升降鍵，看看卷門在上升、下降時是否靈敏。若升降正常，再將門簾上升到所需的位置，將限位螺絲旋緊，調整到滾輪位置，聽到“滴答”一聲后，將螺釘用力鎖緊即可。

Before adjusting the lift, loosen the screws on the limit mechanism, and pull the chain manually to keep the roller shutter door about 1 meter above the ground. Press the lift button of the remote control to see if the rolling door is sensitive when it rises and falls. If the lifting is normal, then raise the door curtain to the required position, tighten the limit screw, and adjust it to the roller position. After hearing the "tick", lock the screw firmly.

注意事項：

matters needing attention:

1、按上升按鈕，當門體向上移動時，看看提升高度是否達到自己所需要求。若高度達不到的話，要再次調試；再按照下降按鈕，等門體停止，再看看末端是否合適。

1. Press the up button, and when the door body moves up, check whether the lifting height meets your requirements. If the height cannot be reached, it shall be debugged again; Then press the down button, wait for the door body to stop, and then see if the end is suitable.

2、檢測急停按鈕。卷簾門在運行時，按下遙控器的急停按鈕，看看卷簾門是否停止，若可以停止表明緊急按鈕處于正常工作狀態。

2. Detect the emergency stop button. When the shutter door is running, press the emergency stop button of the remote control to see if the shutter door stops. If it can stop, it indicates that the emergency button is in normal working state.

3、自動開啟功能調試。檢測卷簾門是否可以準確打開和關閉，并且多角度測試，確定是否信號覆蓋。

3. Automatic start function debugging. Detect whether the roller shutter door can be opened and closed accurately, and conduct multi-angle test to determine whether the omni-directional signal coverage.

4、紅外防砸性能。當門體在下降中，將紅外對射系統中斷試試看，看卷簾門有無迅速反彈上升。在測試時，一定要注意，以免紅外系統出現故障導致砸傷狀況。

4. Infrared anti-smashing performance. When the door body is falling, interrupt the infrared imaging system and try to see if the shutter door bounces up quickly. During the test, be sure to pay attention to safety, so as to avoid the injury caused by the failure of the infrared system.

關于自動卷簾門的升降+-怎么調的相關知識就為大家介紹到這里了，希望對大家有所幫助。如需了解更多相關知識，請繼續關注我們的網站http://m.santoncc.cn平臺，將為大家呈現更多精彩內容。

The relevant knowledge about the lifting and lowering of the automatic shutter door+- how to adjust it is introduced here. I hope it can help you. For more information, please continue to follow our website http://m.santoncc.cn The platform will show you more wonderful content.